|
DPV-35A: 100-156 MHz Ground to Air Antenna |
|
|
|
| Number of Inputs | 1 |
| Frequency Range | 100-156 MHz |
| Maximum VSWR | 2.0:1 |
| Input Impedance | 50 Ohms |
| Maximum Power | 100 Watts |
| Azimuth Patterns | Omni, plus or minus 1 dB |
| Minimum Elevation Beam Width | 65 Degrees |
| Elevation Beam Maximum Location | Horizon, plus or minus 10 degrees |
| Minimum Power Gain | 0 dBi |
| Minimum Isolation | N/A |
| Environmental Conditions | 100 MPH Wind with .5 inches Inches of radial ice |
| Shipping Weight | 10.0 pounds |
| Overall Length | 62.5 inches |
| Radome Diameter | 3.25 inches |
| Equipment Supplied | UG-1185 mating connector, a base adapter to allow mounting to a 1.25" or 2.5" IPS pipe, .375-16 stainless steel mounting bolts |
| Mounting Configuration | The DPV-35A is designed for coaxial mounting on the end of a 1.25" or 2.5" IPS pipe The input connector is sheltered from the environment. |
| Radome Material | The radome is filament wound epoxy fiberglass that exhibits superior environmental capabilities. |
| Finish | The standard finish is gray polyurethane paint on all exterior surfaces. Other colors or finishes available upon request. |
