|
|
|
| Number of Inputs | 1 |
| Frequency Range | 118-136 MHz |
| Maximum VSWR | 2.0:1 |
| Input Impedance | 50 Ohms |
| Maximum Power | 100 Watts |
| Azimuth Patterns | Omni, plus or minus 1 dB |
| Minimum Elevation Beam Width | 40 degrees |
| Elevation Beam Maximum Location | Horizon, plus or minus 10 degrees |
| Minimum Power Gain | 4 dBi |
| Minimum Isolation | N/A |
| Environmental Conditions | 100 MPH wind with .5 inches of radial ice |
| Shipping Weight | 11 pounds |
| Overall Length | 133.75 inches |
| Radome Diameter | 2.35 inches |
| Equipment Supplied | UG-1185 mating connector, a base adapter to allow mounting to a 1.25 or 2.5 IPS pipe, .375-16 stainless steel mounting bolts, and a grounding lug. |
| Mounting Configuration | The DPV-40 is designed for coaxial mounting on the end of a 1.25 or 2.5 IPS pipe. The input connector is sheltered from the environment. |
| Radome Material | The radome is filament wound epoxy fiberglass that exhibits superior environmental capabilities. |
| Finish | The standard finish is gray polyurethane paint on all exterior surfaces. Other colors or finishes available upon request. |
