|
DPV-68: 116-150 & 225-400 & 116-150 Mhz Ground-to-Air Antenna |
|
|
|
| Number of Inputs | 3 |
| Frequency Range | 116-150 & 225-400 & 116-150 MHz |
| Maximum VSWR | 2.0:1 |
| Input Impedance | 50 Ohms |
| Maximum Power | 100 Watts each input |
| Azimuth Patterns | Omni, plus or minus 1 dB |
| Minimum Elevation Beam Width | 65 degrees |
| Elevation Beam Maximum Location | Horizon, plus or minus 10 degrees |
| Minimum Power Gain | 0 dBi |
| Minimum Isolation | 25 dB |
| Environmental Conditions | 100 MPH wind with .5 inches radial ice |
| Shipping Weight | 16.5 pounds |
| Overall Length | 140 inches |
| Radome Diameter | 2.38 inches |
| Equipment Supplied | UG-1185 mating connectors, .375-16 stainless steel mounting bolts, and a grounding lug. |
| Mounting Configuration | The DPV-68 is designed for coaxial mounting on the end of a 2.5 IPS pipe. The input connectors are sheltered from the environment. |
| Radome Material | The radome is a filament wound epoxy fiberglass that exhibits superior environmental capabilities. |
| Finish | The standard finish is gray polyurethane paint on all exterior surfaces. Other colors or finishes available upon request. |
| RF Characteristics | Three vertically polarized dipoles integrated into one radome. The dipoles are mounted one above the other and maintain 30 dB isolation at the same frequency. All metallic parts of the antenna are at DC ground potential. |
