|
DPV-70 (AS-3244): |
|
|
|
| Number of Inputs | 3 |
| Frequency Range | 116-150 & 225-400 & 116-150 Mhz |
| VSWR | 2.0:1 Nominal 3.0:1 Max |
| Input Impedance | 50 Ohms |
| Maximum Power | 50 Watts each input |
| Azimuth Patterns | Omni, plus or minus 1 dB |
| Minimum Elevation Beam Width | 65 Degrees |
| Elevation Beam Maximum Location | Horizon, plus or minus 10 degrees |
| Minimum Power Gain | 1 dBi |
| Minimum Isolation | 30 dB |
| Environmental Conditions | 100 MPH wind with .5 inches of radial ice |
| Shipping Weight | 18.5 pounds |
| Overall Length | 168 inches |
| Radome Diameter | 2.9 inches |
| Mounting Configuration | The DPV-70 is designed for offset mounting to a 3 inch diameter pipe using a permanently attached base. |
| Radome Material | The radome is filament wound epoxy fiberglass that exhibits superior environmental capabilities. |
| Finish | The standard finish is green CARC paint on all exterior surfaces. Other colors or finishes available upon request. |
| RF Characteristics | Three vertically polarized dipoles integrated into two radomes that stack together. The top removable section houses one of the VHF dipoles. The dipoles maintain 30 dB isolation at the same frequency. All metallic parts of the antenna are at DC ground potential. |
| Other Characteristics | The DPV-70 is military nomenclatured as 3244/TS and is intended for tactical ground-to-air communication circuits. |