DPV-75 960-1215 Mhz Antenna |
|
|
|
| Number of Inputs | 1 |
| Frequency Range | 960-1215 Mhz |
| Maximum VSWR | 2.0:1 |
| Input Impedance | 50 Ohms |
| Maximum Power | 250 Watts average, 1000 Watts peak |
| Azimuth Patterns | Omni, plus or minus 1 dB |
| Minimum Elevation Beam Width | 6 degrees |
| Elevation Beam Maximum Location | Horizon, plus or minus 10 degrees |
| Minimum Power Gain | 8 dBi |
| Minimum Isolation | N/A |
| Environmental Conditions | 100 MPH wind with .5 inches of radial ice |
| Shipping Weight | 8 pounds |
| Overall Length | 74 inches |
| Radome Diameter | 3.0 inches |
| Mounting Configuration | The DPV-75 is designed for mounting on telescoping masts. |
| Radome Material | The radome is filament wound epoxy fiberglass that exhibits superior environmental capabilities. |
| Finish | The standard finish is green CARC paint on all exterior surfaces. Other colors or finishes available upon request. |
| RF Characteristics | The DPV-75 is a vertically polarized array of eight dipoles arranged in a collinear array and fed with a microstrip corporate feed network that terminates into a type N connector. The DPV-75 may be converted to a directional antenna (DPV-75A) by the addition of a clamp-on reflector. The omni antenna was designed to support ground-to-air JTIDS class 2 navigational band communications circuits. |